Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recommended gap between letter and arrows?

Status
Not open for further replies.
CorBlimeyLimey

CorBlimeyLimey

Mechanical
Joined
Nov 5, 2003
Messages
15,292
Location
CA
detail.JPG


Is there a recognised standard for this?
 
Sort by date Sort by votes
Readability is the only standard that I am aware of for this situation. Am also very interested to learn if there is an actual standard to cover it.

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]
 
Upvote 0 Downvote
Not sure on that one since my system doesn't even allow that. i did thumb through my drafting book nd found nothing on it. i would assume 2X font total just like anything else.


Solid Edge V20
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

aniiben
  • Question Question
Gap in a feature of size
2
Replies
25
Views
3K
Burunduk
Burunduk
Words_In_Sequence
  • Locked
  • Question Question
Angle of twist between spring hooks
Replies
5
Views
3K
Burunduk
Burunduk
CTengIS
  • Locked
  • Question Question
Differences between ISO GPS and DIN standards?
Replies
8
Views
1K
XL83NL
XL83NL
rkrz
  • Locked
  • Question Question
Parallelism between coaxial cylinders?
Replies
2
Views
524
Eric Gushiken
Eric Gushiken
Jupshaw
  • Locked
  • Question Question
Request for Recommended Approaches for Determining Projection Type in Engineering Drawings
2
Replies
25
Views
1K
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top