Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rads on DIN 59410 and DIN 1022

Status
Not open for further replies.
Speedy

Speedy

Mechanical
Joined
Jun 5, 2001
Messages
229
Location
DE
If someone has the following DIN standards to hand , could they please look up the following please;

The Radii on;

Angle Bar - DIN1022 - 50x50x5 mm
Box Section - DIN 59410 - 70x70x5 mm
Flatbar - DIN1017 - 6x40 mm

Please specify if internal or external radius.

If have to Solid Model the Parts, may as well do it right!
Thanks
Speedy
[bomb]
 
Status
Not open for further replies.

Similar threads

K
  • Question Question
White liquor and steel 316
Replies
1
Views
2K
lucky-guesser
lucky-guesser
tk90
  • Locked
  • Question Question
4140, Surface Hardness, and Coatings
Replies
12
Views
8K
mfgenggear
mfgenggear
dogbural
  • Locked
  • Question Question
Stress relieving on SS316
Replies
6
Views
2K
EdStainless
EdStainless
bekks
  • Question Question
ASME IX PQR - bend test on PJP small diameter pipe
Replies
4
Views
3K
bekks
bekks
TMcRally
  • Locked
  • Question Question
420, 303, and 304 SS and stray current failures
Replies
12
Views
1K
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top