Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

radius compensation on cincinnati milacron 1

Status
Not open for further replies.

pitted

Mechanical
Sep 25, 2006
2

i have a cincinnati milacron turning centre, hawk 150
with A-2100 contoller. When using radius compensation i can use any offset up to 0.4, but anything after that eg:(0.8/1.2) it seems that the machine does not except theses offsets.

has anyone experienced this problem, is it a machine parameter that can be set or changed?

cheers
 
Replies continue below

Recommended for you

cheers bob

i've registered on that site, unfortunately i have to wait for administration to sort me out before i can enter any forum. looks like it could be very helpful.

thanks mate
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor