Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Rack and Pinion Soildworks
- Thread starter timjm25
- Start date
You can fix your rack and let the pinion just mates on the side face and then add the rack/pinion mate.
More on rack and pinion
Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0
More on rack and pinion
Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0
- Thread starter
- #3
There is no best way. The way you decide to fix components within you assembly depends upon your design intent and good modeling practices. You can just fix it in place by clicking on it and selecting "fix". Or you can mate it to another object. Or you can mate it to the reference planes. Or...
Dan
Dan's Blog
Dan
Dan's Blog
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
