"FAILED TO SAVE" ISSUE

[toycept]

I am working in an assembly and creating ribs in a part that is within that assembly . When I go to save the assembly after making the ribs, the window asks to save all referenced documents as well.... I say yes.... Another window pops up, "failed to save".

But if I open up the individual part and make the ribs it saves fine.

Can anyone shed any light why this happens?

Thanks.

 

[SBaugh]

Turn you AutoBackup off and see if that helps... if so then your AutoBackup maybe causes a conflict... maybe the path is incorrect.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users

 

[Regg]

If you save the assembly twice in a row do you get the message?

 

[toycept]

thanks for your follow ups.

I did try saving it... a few times...all failed to save. I had been working with this assembly for a while, saving all along, with no problems. It was just after creating the ribs that the assembly failed to save. Something about those ribs the assembly didn't like. I went ahead and created the ribs at the part level... it rebuilt fine when I went back into the assembly.