Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

question about the assembly meshing

Status
Not open for further replies.
tmao

tmao

Mechanical
Joined
Mar 18, 2010
Messages
1
Location
US
It's a simple structure, but it can not be meshed. there always have some parts missing. Then I used the mesh control for the parts that can not be meshed, still cannot make it, feel very frustrated.
 
Sort by date Sort by votes
More mesh control, defeature if necessary. Isolate one part at a time that fails, work on that until you find the problem, repeat for failed parts then run you assembly again after you have resolved all the problems.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

RF-ME
  • Locked
  • Question Question
Earthmoving - Fixture question
Replies
2
Views
950
RF-ME
RF-ME
ElMicha
  • Locked
  • Question Question
How To Run FEA on Nut-Bolt Assembly
Replies
7
Views
1K
3DDave
3DDave
oharag11
  • Locked
  • Question Question
Error - Please enter a value greater than 0 - Thermal Joint?
Replies
0
Views
989
oharag11
oharag11
Champ58
  • Locked
  • Question Question
Buckling Analysis of Assembly
Replies
1
Views
396
FEA way
FEA way
seraph3333
  • Locked
  • Question Question
IR LED solidworks thermal simulation unexpected extreme low temperature problem
Replies
2
Views
330
seraph3333
seraph3333

Part and Inventory Search

Sponsor

Back
Top