Quarter and half section in assembly

[automatiks]

Hi,

I have an assembly which consist of 2 sub-assemblies. I've been told to make a drawing of this assembly and show on view one sub-assembly as a half section and the other one as quarter section. Does anyone one know how to do that?

thanks
automatiks

 

[SRINIVASANIYER1]

You need to include the two sub assemblies, Activate them
one by one, Insert their views and create sectional views.
e.g. Let us say the Assembly a consists of sub assemblies
SA1 ans SA2.
While in Drawing...
Files --> properties -->Drawing Models --> Add...{add
SA1 and SA2}.
Drawing Models --> Set --> SA1 {This sets SA1 as the
Current model}
Insert Views of SA1 and create section views.
Repeat for SA2.

 

[SRINIVASANIYER1]

You need to include the two sub assemblies, Activate them
one by one, Insert their views and create sectional views.
e.g. Let us say the Assembly a consists of sub assemblies
SA1 ans SA2.
While in Drawing...
Files --> properties -->Drawing Models --> Add...{add
SA1 and SA2}.
Drawing Models --> Set --> SA1 {This sets SA1 as the
Current model}
Insert Views of SA1 and create section views.
Repeat for SA2.

 

[automatiks]

Thanks for advise. I had to do this view for presentation purpose, so I have literally made a half section on SA1 and quarter section on SA2. Then I put them into assembly and shown isometric view. I know that's not a proper way to do that, but it very urgent.
However I'm going to check the way you suggested.

thanks
automatiks