brandonl
Structural
- Dec 19, 2003
- 12
If I wish to specify that a 3/4" diameter A307 threaded rod be butt welded to a flat plate or beam flange using a full penetration weld:
1. Is a weld symbol required, or would simply stating with a plan note that a fiull penetration weld be used be adequate?
2. If a weld symbol is not required, what type of end treatment should the welder perform on the end of the rod in order to properly complete the full pen weld?
3. If a weld symbol is required, what would be the proper symbol (or where might I look to find the proper symbol)?
4. What are the specifications/codes/publications that address such welding?
1. Is a weld symbol required, or would simply stating with a plan note that a fiull penetration weld be used be adequate?
2. If a weld symbol is not required, what type of end treatment should the welder perform on the end of the rod in order to properly complete the full pen weld?
3. If a weld symbol is required, what would be the proper symbol (or where might I look to find the proper symbol)?
4. What are the specifications/codes/publications that address such welding?