Sep 16, 2005 #1 Dundas Mechanical Sep 16, 2005 1 I have added an expansion block (I/O) onto a Mitsubishi FXon series PLC. How do I address the additional I/O in my program??
I have added an expansion block (I/O) onto a Mitsubishi FXon series PLC. How do I address the additional I/O in my program??
Sep 16, 2005 #2 Rheinhardt Industrial Oct 13, 2004 64 As far as i know depending on your position on the backplane determines your adressing for that data area. You would have to look threw the CPU documentation to determine the offset.. I stand correctd as i did most of my work on the q-series. Just a thought Upvote 0 Downvote
As far as i know depending on your position on the backplane determines your adressing for that data area. You would have to look threw the CPU documentation to determine the offset.. I stand correctd as i did most of my work on the q-series. Just a thought
