Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
programmaticaly switch between modes
- Thread starter Ehaviv
- Start date
To my best knowledge no.
There are certain environment settings which need to be done for which NX needs a restart.
Also, the storage of your data is completely different of course.
Of course you can do this with code but not without closing any data you have opened at the time of execution.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX11 / TC11
There are certain environment settings which need to be done for which NX needs a restart.
Also, the storage of your data is completely different of course.
Of course you can do this with code but not without closing any data you have opened at the time of execution.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX11 / TC11
- Thread starter
- #3
- Status
Similar threads
