process of machining a complex shape in Nx without close the holes?

[lamloum]

Good afternoon everyone,I need your help to do the process of machining a complex shape in Nx with holes,I found un exceed material just over the holes .
shoud I close the holes to do the shape or there's an easy solution?

thinks for your helps​

 

[markrief]

It's usually easiest to just cover the holes. On the Manufacturing ribbon, in the Geometry group. look for Patch Openings on the drop down.

Mark Rief
NX CAM Customer Success
Siemens PLM Software

 

[lamloum]

Thanks Markrief,how about machining the holes? shoud I open it again?
please may you send me link or vedio about this(doing the shape and the holes).
Thanks