Hello,
I am working in NX11 mechanical routing. I want to create a new stock to the reuse library so I created the cross section in a sketch and qualified it with a cross section (simple and detail), prepared the part family spread sheet as well as the .ptb and .plv file. Everything is looking good until I try to assign the stock to a routing path. Then I get the alert "A cross section of the required style has not been defined for the selected stock. Create a cross section using Qualify Part." But this actually has been done. See pictures attached.
Anyone who has any ideas?
Best regards.
I am working in NX11 mechanical routing. I want to create a new stock to the reuse library so I created the cross section in a sketch and qualified it with a cross section (simple and detail), prepared the part family spread sheet as well as the .ptb and .plv file. Everything is looking good until I try to assign the stock to a routing path. Then I get the alert "A cross section of the required style has not been defined for the selected stock. Create a cross section using Qualify Part." But this actually has been done. See pictures attached.
Anyone who has any ideas?
Best regards.