I'm having a tough time with the Probe Results command in Cosmosworks. I have a cylinder that I have probed many locations and I would like to simulate the probed locations on stress result and strain result plots. I have created the Sensor-1 that has all of my locations and even saved it to my hard drive to see that it is saved. When I go to a different plot and click "probe" and then "from Sensors" the option Sensor-1 appears but does not populate the results area. If I get out of the Probe mode and go to the pulldown menu Cosmosworks-Sensors, all of my probed values appear correctly under "locations". This is driving me crazy. Please help. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Probe Results, Sensor
- Thread starter reilly22
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question