Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro/E: stl file into surfaces

Status
Not open for further replies.
nels

nels

Bioengineer
Joined
Dec 12, 2001
Messages
2
Location
US

Is there a way to convert an ".stl" file into surfaces in Pro/Engineer 2000i2?
 
Sort by date Sort by votes
Hi,
Try convering the file into IGES and then try to export to pro/e.
This may work
mechm
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Question Question
Osai OD700 service manual or at least error codes list? (E-53)
Replies
0
Views
2K
Azorath
A
MechEng275
  • Locked
  • Question Question
Hex Standoff inserted into baseplate thread failure
Replies
1
Views
378
3DDave
3DDave
elinah34
  • Locked
  • Question Question
Increasing a coefficient of friction between 2 surfaces
2
Replies
26
Views
2K
elinah34
elinah34
legepe
  • Locked
  • Question Question
form a pipe into a cone/spherical shape?
Replies
19
Views
2K
EdStainless
EdStainless
jpowers
  • Locked
  • Question Question
Determining bearing pressure between mating convex and concave conical surfaces?
Replies
2
Views
394
jpowers
jpowers

Part and Inventory Search

Sponsor

Back
Top