Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro/E import configuration

Status
Not open for further replies.

Baldy217

Mechanical
Joined
Jun 7, 2007
Messages
41
Location
US
I just installed ANSYS v11 and I'm trying to configure Proe/E so I can import. When I open ANS_ADMIN, I don't have the Pro/E option like I had in 10. ANSYSGeom is integrated in Pro/E but it takes 5 minutes just to import a plate. Any help is appreciated.

Oh and I'm running Wilfire 3.0 M070.
 
If you look in the release notes, you'll see that they removed this utility from the ANS_ADMIN utility.

The settings are now defined in the config.anscon file.

Hope this helps,
Doug
 
Thanks a lot doatis

"Pro/ENGINEER and Unigraphics configuration can now be completed as part of the ANSYS or ANSYS Workbench installation"

Ok, but what if the installation didn't get it right? Going from Pro/E to ANSYS works fine now, but importing from ANSYS still doesn't work.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top