Print resolution

[Duds66]

I have to print a draw of a very smal part (dimensions are abt 1mm X 1mm )with SW2005 SP3
In SW windows, the draw is correct, but when i print, I have facets on circles. If i creat a print preview, I can see these facets.

- I use a general scale of 50:1
- I created High quality views
- In the document properties, quality image is set on "High"
- In the page setup, i print with a scale "100%" and "High quality" is enable.
- print option, "convert draft quality drawing views to high quality" is enable

Is there a hidden option i have not seen????

 

[SBaugh]

Check your printer options and the windows options as well.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users

 

[Duds66]

i check my printer options, but everything is set on "high quality".
But what do you mean when you say "check the windows options" ?

 

[SBaugh]

Windows has printers in there, check their options. When I say printer I mean there are printers that have their own options outside of windows.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users