Primary & Required Attributes Settings? NX 11

[3dr]

Where are these defined at? I can't find anything on this.

I think I'd like to set my part list specific attributes as "Primary"
The Bulk Editor can be set to only show "Primary" Attributes.
It seems like it could help a lot when making entries there.
All the other clutter would be out of the way.


Anyone out there doing this already?
I'm interested in any tips or tricks that would make the bulk editor easier to use.






Dave
Automotive Tooling / Aircraft Tooling / Ground Support Structures

NX9, Win 7 Pro SP1

 

[3dr]

I should have mentioned that I run NX in Native mode, not Team Center.


Dave
Automotive Tooling / Aircraft Tooling / Ground Support Structures

NX9, Win 7 Pro SP1