Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Potassium acetate material compatibility 1

Status
Not open for further replies.
NotToScale

NotToScale

Industrial
Joined
Jun 4, 2009
Messages
5
Location
US
Can anyone please advise what materials should be used in a component seal for that?
 
Sort by date Sort by votes
Parker recommends EPDM for elastomers. 316S/S is good for wetted parts and Silicon Carbide Vs Carbon will be good, so a stanndard cartridge seals should be goood for this application.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Ramadan Ahmed
  • Locked
  • Question Question
IP68 Rubber Material
Replies
4
Views
1K
satthepbienhoa
satthepbienhoa
Anbu2410
  • Locked
  • Question Question
Stress induced and deformation due to line contact between two different materials
Replies
0
Views
298
Anbu2410
Anbu2410
Loganathan_76
  • Locked
  • Question Question
material selection problem
Replies
0
Views
152
Loganathan_76
Loganathan_76
engpes
  • Locked
  • Question Question
FRP Gasket Material
Replies
0
Views
292
engpes
engpes
nwachuks
  • Locked
  • Question Question
How do you handle expansion between dissimilar materials
Replies
2
Views
345
lukin1977
lukin1977

Part and Inventory Search

Sponsor

Back
Top