Bagman2524
Structural
Does anyone know how to edit reaction information in the postprocessign mode of STAAD? I want to only show vertical or horizontal reactions and remove the moments.
Thanks
Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Postprocessing Reactions
- Thread starter Bagman2524
- Start date
- Status
SteveGregory
Structural
In the post-processor, select all of the nodes, select "Support Reactions" in the reports menu. When the reactions are displayed, click on the upper left corner block labeled "Node". This selects the entire table. Now press Ctrl-C to copy it to the clipboard. Open Excel and paste it into a blank spreadsheet. Everything will be copied into separate columns. Now you can delete the columns that you don't want.
- Status