Post builder - millimeters vs. inches

[sitti]

Hello,

Is it possible to change the post output unit in a default pp?
If I open lathe_tool_tip.pui, I can't see where to do it.

Thanks

 

[shags72]

The only way I have known is to make a new post using the old one as a template and change the units. This may have changed since I have not been using for a few months but I doubt it. Good luck.

 

[markrief]

The units of the post are determined when it is created.
In NX8, we added the ability for a dual units post. This is done with a sub-post that contains only the settings that are different between the units.

Mark Rief
Product Manager
Siemens PLM