Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Post Builder for output Workpiece

Status
Not open for further replies.
nxexplorer

nxexplorer

Mechanical
Jun 23, 2010
84
Our customer is using Siemens Controller of their cnc, in the sample of its nc code, at the begining of block lines, there is WORKPIECE(,,,"BOX"...

Need help for calling this values in Post Builder.

Regards,
NXExplorer
 
Status
Not open for further replies.

Similar threads

AlexCLE
  • Locked
  • Question
Post builder change full circles to shorter arcs
Replies
0
Views
976
AlexCLE
AlexCLE
nxexplorer
  • Locked
  • Question
NX Post Builder make the coordinate output G01X.25Y-.573 become G01X0.25Y-0.573
Replies
0
Views
250
nxexplorer
nxexplorer
S
  • Question
Define POST-Actions for Loading from different options
Replies
0
Views
1K
sbjw
S
jopek323
  • Locked
  • Question
NX Post Builder Rotary AUTOCLAMP
Replies
0
Views
236
jopek323
jopek323
Petetheprogrammer
  • Locked
  • Question
Siemens NX Post Builder post processor with Sub programs
Replies
1
Views
593
joycejo
joycejo

Part and Inventory Search

Sponsor

Back
Top Bottom