Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Port mould materials 1

Status
Not open for further replies.

Aled87

Automotive
Joined
Mar 1, 2010
Messages
24
Hi guys,
I'm looking to make a mould of a port for flowbench calculations, what paste/sealant should i use to make a good port mould.
thanks
 
Silicone Mould Making Rubber, search online for it, theres loads of types. Be sure to apply an agent to port so you will be able to withdraw compound when set.

Is this what your after?

BG
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top