Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Point Style in SW

Status
Not open for further replies.

brownnote

Mechanical
Joined
Jun 6, 2002
Messages
2
Location
US
Is there a way to change how points are displayed on a drawing? I have shown a 3D sketch that is just points. The points are representations of holes on the part. When I plot out the drawing the points get absorbed by my centerlines.

I now need to change the way that the points are displayed. In AutoCad you could tell the software if you wanted to have a cross or an X for points. I have yet to find anything in SW.

Does anyone have a Macro that would lay an X or a cross onto existing points in a drawing.

Your help is appriciated.
 
To the best of my knowledge there is no way to change the display type of a point. The only types of points you can change are the virtual sharps.



Regards,
Jon
jgbena@yahoo.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top