Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plus/minus variations for draft

Status
Not open for further replies.
unavuh

unavuh

Mechanical
Feb 24, 2009
2
thread1103-275160

Where can I find a standard reference to this ? There is any chapter, in ASME regarding this. I know there is a European DIN (16901 pg 3) related but what is the standard used in ANSI, ASME, etc.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
ASME Y14.8-2009 Castings,Forgings, and Molded Parts.
An earlier version is ASME Y14.8M-1996.

Season
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Vladdo
  • Locked
  • Question
Using dimension with plus minus tolerance at intersection of basic dimension.
Replies
6
Views
421
Vladdo
Vladdo
M
  • Question
Dimensions for a u-bolt
Replies
2
Views
2K
Doug Hunter
Doug Hunter
sendithard
  • Locked
  • Question
Does a gouge in a part affect a plus minus dimension
Replies
4
Views
128
greenimi
greenimi
MPSU
  • Question
Positional tolerance twice for same Stud
Replies
12
Views
2K
MPSU
MPSU
H
  • Question
Composite Position with separate requirement for pairs of features
Replies
19
Views
5K
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top Bottom