Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
PLIST IGNORE MEMBER 2
- Thread starter flam04
- Start date
-
1
- #2
JohnRBaker
Mechanical
The 'PLIST_IGNORE_MEMBER' attribute is created automatically for all Components in an Assembly. Just select the Component of interest, press MB3, select Properties -> Attributes and in the 'Unset' Category you should find the 'PLIST_IGNORE_MEMBER' attribute. Just select it, set its value to 'Yes', hit return and then OK.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
-
1
- #5
- Status
Similar threads
- Locked
- Question
- Locked
- Question