jeffcurrey
Mechanical
- Apr 5, 2002
- 2
Sirs,
What a great website!
My question is regarding AISC specs on holes designed for connection plates using HS bolts. Is it primarily a dimensional requirement? If so, what about the slight taper created by in the kerf of the cut? We are interested in burning these plates vs. layout/punching due to the ease of manufacture.
Thank you in advance,
Jeff
What a great website!
My question is regarding AISC specs on holes designed for connection plates using HS bolts. Is it primarily a dimensional requirement? If so, what about the slight taper created by in the kerf of the cut? We are interested in burning these plates vs. layout/punching due to the ease of manufacture.
Thank you in advance,
Jeff