Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plating for Invar 36 parts?

Status
Not open for further replies.
alderetm

alderetm

Mechanical
Joined
May 22, 2002
Messages
3
Location
US
Does anyone have advice regarding the need for plating Invar 36 parts? Our parts will see temperatures as low as 80K during operation. I'm wondering if passivation provides adequate corrosion protection.

Thanks in advance. Michael Alderete
Mech Packaging Engineer
DRS Technologies-Sensors & Targeting Sys
Anaheim CA
 
Status
Not open for further replies.

Similar threads

rollingcloud
  • Locked
  • Question Question
Best method to verify NI/CR plating composition?
Replies
7
Views
856
EdStainless
EdStainless
FrancoisY
  • Locked
  • Question Question
Salt Spray Test - If Multiple Parts are being analyzed
Replies
5
Views
3K
mfgenggear
mfgenggear
quizzical1
  • Locked
  • Question Question
Surface finishes for molded rubber parts...
Replies
0
Views
280
quizzical1
quizzical1
Radius1
  • Locked
  • Question Question
Looking for specification for identifying pearlite in cast iron sample.
Replies
0
Views
2K
Radius1
Radius1
BSMEclassof2012
  • Question Question
Brine concentration for pumps made from ductile cast
Replies
1
Views
1K
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top