Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pits in tubing surface

  • Thread starter Thread starter wh
  • Start date Start date
Status
Not open for further replies.
wh

wh

Mechanical
Joined
Feb 22, 2002
Messages
7
Location
US
Is there a grade specification for tubing which controls the surface finish against pitting? Samples I have been receiving have pits and I wish to create an o-ring seal along the outer surface. Primary tubing material is stainless steel and brass.
 
Status
Not open for further replies.

Similar threads

Prometheus21
  • Locked
  • Question Question
Stainless Steel tubing PQE, CQE,CQ,CQM
Replies
6
Views
675
Prometheus21
Prometheus21
gatossi
  • Locked
  • Question Question
PFA Liner detached from flange surface
Replies
4
Views
475
EngrPaper
EngrPaper
mariolucas75
  • Locked
  • Question Question
Piping leak repair with "something" that does not need surface preparation
Replies
12
Views
4K
monang77
monang77
K
  • Question Question
Pneumatic test in refinery construction
Replies
4
Views
13K
John Taylor
John Taylor
F
  • Question Question
Compensating pressure in Cryogenic Storage Tank
2
Replies
26
Views
27K
GD2
GD2

Part and Inventory Search

Sponsor

Back
Top