Pipes in Sheet Metal

[michael3130]

Hi,


Does anyone know a way to model bent pipes in sheetmetal and then straighten them out without having the use of the piping module.


I am trying to model a heating element but would really like to do it so I can straighten it afterwards.


Any help would be appreciated.


Thanks


Michael

 

[prohammy]

Michael,


Take a look at this thread...good starting point


Kev


[url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=31 657&KW=unbend+a+pipe[/url]http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=31 657&KW=unbend+a+pipe


EDIT:-


Try sending DELL_BOPY a Private Message to get the solution

Edited by: prohammy