mmartens
Mechanical
- Jul 17, 2001
- 24
I am trying to determine / calculate the capacity of a pile that is being installed with a hydraulic hammer attached to an excavator. The hydraulic hammer has
a manufactures power rating of 3577 Joules operating at 320 to 600 hammer blows per min. the operator is pushing down on the hydraulic hammer with all the added weight of the excavator (i.e. the tracks are in the air). The pile is being penetrated at a rate of about 40 to 50 mm per min.
Any Thoughts?
a manufactures power rating of 3577 Joules operating at 320 to 600 hammer blows per min. the operator is pushing down on the hydraulic hammer with all the added weight of the excavator (i.e. the tracks are in the air). The pile is being penetrated at a rate of about 40 to 50 mm per min.
Any Thoughts?