Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

pH parameter

Status
Not open for further replies.
metboss

metboss

Petroleum
Joined
Sep 12, 2012
Messages
153
Location
AE
Hi all,

NACE TM-0177 test (method A) was conducted on 2 samples (material L-80 13% Cr) and at the end of test (>720 hrs.’) pH values observed: 4.06 & 4.10 respectively. Please advise if these pH values are acceptable? Can we consider this test (NACE TM-0177 method A) as acceptable ?

Regards
 
Status
Not open for further replies.

Similar threads

W
  • Locked
  • Question Question
Aging Composition of 15-5 PH
Replies
3
Views
3K
EdStainless
EdStainless
Laishetti
  • Locked
  • Question Question
Casting powder for 17-4 PH
Replies
5
Views
506
Laishetti
Laishetti
tl-sign
  • Locked
  • Question Question
Drawing notes for surface condition after heat treating 17-4 PH
Replies
1
Views
359
mfgenggear
mfgenggear
bekks
  • Locked
  • Question Question
Sigma phase in 2205 duplex
Replies
8
Views
862
EdStainless
EdStainless
bekks
  • Locked
  • Question Question
Improperly Heat Treated 17-4 PH
Replies
4
Views
640
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top