Does anybody know how to have the perimeter measurement go to a configuration specific info. When we design a laser cut part we want the total cutting inches to fill in a section on the Titleblock, and if that could be automated it would save quite a bit of time rather than keying it in manually. I looked in the API help and could not find anything. I am not sure if this can be done without a macro or not.
Don't worry about people stealing your ideas. If your ideas are any good, you'll have to ram them down people's throats.
--Howard Aiken, IBM engineer
Don't worry about people stealing your ideas. If your ideas are any good, you'll have to ram them down people's throats.
--Howard Aiken, IBM engineer