J
jonasbp
Guest
I am trying to make a ring that controls 20 guide vanes. I
have done this by creating a motion skeleton with 1/20
part of the system. I get this part to work the way i
want, but I would like to create a pattern around the
center axis with each piece moving equal. I have tried
several different methods, but can not get this to work.
It is only the reference part that works properly while
the other parts are no longer connected to each other.
001.jpg">002.jpg">
have done this by creating a motion skeleton with 1/20
part of the system. I get this part to work the way i
want, but I would like to create a pattern around the
center axis with each piece moving equal. I have tried
several different methods, but can not get this to work.
It is only the reference part that works properly while
the other parts are no longer connected to each other.
001.jpg">002.jpg">
