DonneyJW
Aerospace
- Feb 24, 2012
- 1
Patran 2010 installed on Windows 7 x64 but only opens in small window.
If resized only the original area is visible.
Any ideas?
I remember a similar issue with Patran 2006/7 with the file > new/open/save window not fully displaying which was overcome by repositioning the "file new" window, escape and reopen.
If resized only the original area is visible.
Any ideas?
I remember a similar issue with Patran 2006/7 with the file > new/open/save window not fully displaying which was overcome by repositioning the "file new" window, escape and reopen.