Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Parameters for PF 700 and regen Unit

Status
Not open for further replies.
krsh

krsh

Electrical
Joined
Nov 10, 2010
Messages
54
Location
RO
Hello,
I am using a PowerFlex 700 drive for a pump jack application on a 500V not grounded power network. I want to install a regenerative unit(Revkon SVC) for this drive and i want to know what parameters i need to change. I also need to know what is the simplest way to know how much energy is regenerated.
Thank you.
 
Status
Not open for further replies.

Similar threads

SA07
  • Question Question
To replace faulty power alternator with a smaller unit
Replies
19
Views
8K
mfgenggear
mfgenggear
NickParker
  • Question Question
Reactance and Time constant tests for a generator
Replies
7
Views
7K
wcaseyharman
wcaseyharman
T247
  • Locked
  • Question Question
Sync Motor PF Trip
2
Replies
27
Views
2K
edison123
edison123
bacon4life
  • Locked
  • Question Question
Impacts of loss of excitation on small hydro unit
Replies
12
Views
4K
RRaghunath
RRaghunath
EEENGRX
  • Locked
  • Question Question
Installation of float and pressure switch for motor control
Replies
10
Views
4K
SilverfoxUK
SilverfoxUK

Part and Inventory Search

Sponsor

Back
Top