Feb 3, 2002 #1 robert777 Chemical Feb 24, 2005 1 does anyone know how you go about calculating the diameter of a ground station dish required to deliver 1pW to th receiver.
does anyone know how you go about calculating the diameter of a ground station dish required to deliver 1pW to th receiver.
Feb 3, 2002 #2 dpc Electrical Jan 7, 2002 8,716 I think this would depend on where your receiver is located, the gain of the receiving antenna, and the transmission losses. Upvote 0 Downvote
I think this would depend on where your receiver is located, the gain of the receiving antenna, and the transmission losses.
Feb 4, 2002 #3 cbarn24050 Industrial Jan 20, 2002 709 you also would need to know the transmitter power output and its antenna gain. Upvote 0 Downvote
Feb 22, 2002 #4 Lewish Electrical Feb 8, 2002 456 Path loss is also a function of frequency, so you need to know that. I assume this is a microwave signal. Upvote 0 Downvote
Path loss is also a function of frequency, so you need to know that. I assume this is a microwave signal.
