Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Paper Cytters vs. .005 mill foil. 1
- Thread starter mikski33
- Start date
-
1
- #2
MikeHalloran
Mechanical
It probably wouldn't like stainless steel foil. You didn't mention a material.
Mike Halloran
Pembroke Pines, FL, USA
Mike Halloran
Pembroke Pines, FL, USA
We just use fiskars desk scissors.
Our paper cutter doesn't cut closely enough to give clean cuts.
Thomas J. Walz
Carbide Processors, Inc.
Good engineering starts with a Grainger Catalog.
Our paper cutter doesn't cut closely enough to give clean cuts.
Thomas J. Walz
Carbide Processors, Inc.
Good engineering starts with a Grainger Catalog.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
