Had to post again to correct my spelling and specify a little more. We currently operate a Harris-Seybold Citation paper cutter in our workplace. Is there any reason not to cut .003 and .005 aluminum foil down to a working sheet size on this machine? Was it designed to handle this? The foil actually consists of a 1 mill layer of aluminum foil plus a polyester backer to make up the difference in thickness.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Paper Cutters and foil
- Thread starter mikski33
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
