Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Panel Development
- Thread starter garys
- Start date
ok who took geometry in high school
ok to figure out how to make a flat sheet that when rolled = a con what do you do
Circumfrence of the bottom of the cone draw a line = to that then from the midpoint of that line draw a nother perpendicular to it at a length = to the side height of the cone and there you have it
now if you want a quicker way to do it someone could easily create a lisp to do all that for you
ok to figure out how to make a flat sheet that when rolled = a con what do you do
Circumfrence of the bottom of the cone draw a line = to that then from the midpoint of that line draw a nother perpendicular to it at a length = to the side height of the cone and there you have it
now if you want a quicker way to do it someone could easily create a lisp to do all that for you
- Thread starter
- #4
- Thread starter
- #5
I found this. This is what I was looking for. Might help others.
Gary
Gary
- Status
Similar threads
- Locked
- Question