If you own an L3050, do you have problems with your axes control? I have been having problems with gantry balance and Y-Axis position detection since day one. Z-Axis problems also. They have replaced my Y-Axis scale 2 times already, Z-Axis scale once, leveled the machine 2 times, have been invoquing floor problems (even though the field engineer that came to install the machine certified it was ok) all of this during the course of a year and a half.What software version do you run? Any hints would be helpful...
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Owners of Trumpf L3050...
- Thread starter tikrik
- Start date
Similar threads
- Locked
- Helpful tip