Can anyone know how to make the safety factor uplift (ULS) appear in the load case for design in prokon?I've tried to input the same data but when it comes to the design part I'm getting safety factor slip (SLS).I don't know if I need to setup any parameters for it to be changed.And I'm using the code BS8110 - 1997.Kindly check the attached file for reference of the correct output.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Output for Load Case in Prokon Software
- Thread starter qwerty122
- Start date
Similar threads
- Question
- Question