Chris33780
Mechanical
Using SolidWorks 2010, the drawing mode defaults to 1st angle projection. Is there a method to change the setting so that it is 3rd angle projection?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Orthographic Projection 1
- Thread starter Chris33780
- Start date
- Status
-
1
- #2
Change your template.
In the tree view, right-click on Sheet, then properties, change to 3rd angle, save template.
Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion
In the tree view, right-click on Sheet, then properties, change to 3rd angle, save template.
Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion
- Thread starter
- #4
- Status