Orienting WCS in NX7.5

[NorthwesternDesign]

We recently migrated to 7.5 from 5 and are trying to adjust to the differences. One thing I noticed different is while in an assembly, in NX5, you could orient the WCS to edges of a model. In NX7.5, you have to make the part you are selecting your work part. Is there some setting to go back to the old way?

Northwestern Product and Tool Design

http://www.northwesterndesign.net/

 

[NorthwesternDesign]

Figured it out! My selection filter was set to "Work Part only" instead of "Entire Assembly"