Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ordinate Dimensioning Origin Indicator

Status
Not open for further replies.
crh07

crh07

Mechanical
Joined
Jun 22, 2007
Messages
1
Location
US
I am using Inventor 10, and have a problem getting rid of the origin indicator (dowel pin symbol) that is placed when an ordinate dimension is created. The symbol can be hidden, but I cannot find a way to delete it. Any advice would be much appreciated. Thanks.
 
Sort by date Sort by votes
If you delete your origin indicator, then how will IV now where the dimension is taken from (point of reference?)

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

cadmate
  • Locked
  • Question Question
Origin Indicator
Replies
3
Views
572
mcgyvr
mcgyvr
cbell1007
  • Locked
  • Question Question
How do I restore original constraints when opening a STEP file in Inventor?
Replies
5
Views
852
rollupswx
rollupswx
etxxx
  • Locked
  • Question Question
Autodesk Inventor: point of origin + angle + views + measure tool
Replies
7
Views
533
btrueblood
btrueblood
FUTURA4L
  • Locked
  • Question Question
How to set Ordinate Dimension to be above Line
Replies
2
Views
200
FUTURA4L
FUTURA4L
rep001
  • Locked
  • Question Question
ORDINATE DIMS IN A DETAIL
Replies
4
Views
264
rep001
rep001

Part and Inventory Search

Sponsor

Back
Top