One-sided diameter after NX8.5 1

[PrintScaffold]

Helly everyone!

In NX8.5 it was possible to measure one-sided diameter by selecting axis using name assigned to this axis.
Is the same possible in NX9?

http://www.cadroad.com

 

[JohnRBaker]

YES. Simple add the 'Name Selection' widget to the Selection Bar and as you're creating a Cylindrical Dimension, when asked for to 'Select second object...', type the name assigned to the cylinderical axis in the 'Name Selection' widget and you should be good to go (as per the attached video clip).

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[PrintScaffold]

Thank you, John!

http://www.cadroad.com