OLD WESTINGHOUSE MOTOR OUTLINE DRAWING NEEDED

[etom]

Can anybody point me to where I can find the outline drawings for a C8-4A45 induction motor, this is a 800 hp motor....above NEMA

 

[dpc]

http://www.tecowestinghouse.com/

But I wouldn't get your hopes up. You'll need a serial number or order number.




David Castor

http://www.cvoes.com

 

[jraef]

I once had to get some old West. motor drawings from Teco after the fall of W, cost me $150.00 and that was 20 years ago now. Be prepared.

"If I had eight hours to chop down a tree, I'd spend six sharpening my axe." -- Abraham Lincoln
For the best use of Eng-Tips, please click here -> faq731-376

 

[starkopete]

What is the frame size?

Thanks

 

[jraef]

Me? Above NEMA, 500HP 2300V. Turned out to be a custom motor designed for a fan, it was rated for 1 cold + 1 hot start PER DAY! Had a 2-1/4" shaft too, it turned out to be basically useless. But the end user got a "great deal" on it. We were trying to figure out if it could be used on a Banbury mixer (rubber shredder for a tire plant). Wasn't even close.

"If I had eight hours to chop down a tree, I'd spend six sharpening my axe." -- Abraham Lincoln
For the best use of Eng-Tips, please click here -> faq731-376

 

[starkopete]

Sorry jraef, my question was for etom. C8-4A45 seems more like a model number, I have some old critical dimensional files but they go by frame size.

Thanks