Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX9 - DXF/DWG Export
- Thread starter phillpd
- Start date
- such as ?
- I did some testing a week ago in 9.0.2 and did not see any issues. - Rather the opposite, i was amazed on how good ( some of ) the results was.
And i learnt that AutoCAD now can read both NX and JT files. - It imports the solids very nice.
- The direct import does not translate drawings, only 3D data.
Regards
Tomas
- I did some testing a week ago in 9.0.2 and did not see any issues. - Rather the opposite, i was amazed on how good ( some of ) the results was.
And i learnt that AutoCAD now can read both NX and JT files. - It imports the solids very nice.
- The direct import does not translate drawings, only 3D data.
Regards
Tomas
- Thread starter
- #3
Arkance/PhoeNX
Mechanical
Just tested an export to DWG in NX9.0.3 and no fatal errors here.
Anthony Galante
Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.2, NX10 Beta
Anthony Galante
Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3
NX8.5.0 -> NX8.5.3, NX9.0.0 -> NX9.0.2, NX10 Beta
- Status
Similar threads
- Locked
- Question