NX9 Drawing Size

[NXJockey]

All,

I have been working on a old NX7.5 drawing 'UGPART' whcih has now been revised using NX9.

Only minor changes have bee made to the drawing (a few notes and a composite section view)

The part file has jumped from 45mb to 111mb

Does anyone have any experience of this, is there a work around, is it a known issue?

cheers in advance,

NX Jockey

 

[kapmnit123]

Hi,
Did you use refile (in NX9)?
Best Regards
Kapil

 

[NXJockey]

Hi, initially no, then refiled in the hope it would help but actually made no difference

 

[SDETERS]

Did you try doing a part cleanup?

 

[cowski]

In the save options you will find "compress part on save". Perhaps this was turned on in your NX 7.5 options and is turned off in your NX 9 options.

www.nxjournaling.com