Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX8.5 motion simulation. "Marker is not associated with geometry" warnings

Status
Not open for further replies.

john325

Mechanical
Joined
Mar 5, 2014
Messages
1
Location
US
I am trying to perform a motion simulation in NX8.5 (Recurdyn solver). I am wondering how trustworthy the data is going to be, because I keep getting the following warnings for every joint in my simulation except the 'fixed' joint (I have ten joints):

base_to_balance_link Warning: I marker is not associated with geometry
base_to_balance_link Warning: J marker is not associated with geometry

I thought that making a new simulation by checking the box "Environment > Component-based simulation" would get rid of these warnings, but it did not. My simulations seem to run okay, and I can get force data graphs with the "load transfer" feature.

Are these warnings something I should be concerned about? If yes, then how do I fix the problem?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top