NX6 crashing when I move toolbar

[ArevZ]

thread561-302787

I know there have been some posts on this topic awhile ago but this problem still persists. I was running NX6 on a windows XP workstation last week but today I got a brand new windows 7 64bit workstation. After reading the other posts on this, I removed IE (was IE 11) but that did not fix it. Is there anything else I could try?

 

[JohnRBaker]

It sounds like a graphics card/driver issue. Make sure that you're using a supported graphics card with the correct (i.e. certified) driver.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.